Delivery and installation of RDGEs and drying cabinets
About This Opportunity
TranslatedPlanning, construction, delivery, installation, and validation of cleaning and disinfection devices, drying cabinets, and accessories for documentation in the inventory system.
This is a supplies contract in the health and medical services sector. Located in Germany, Europe, this opportunity is open to firms and consortiums.
Published through TED - Tenders Electronic Daily (EU), a national government procurement portal. Public procurement tenders follow the country's national bidding regulations and may have specific eligibility and documentation requirements for the supply of goods in the health and medical services sector. Supply contracts typically require bidders to demonstrate product compliance with technical specifications, delivery capacity, and relevant certifications. This contract has already been awarded. The information is published for transparency and market intelligence purposes.
Description
Auto-translated from GermanPlanning services, construction services, delivery, installation, and validation of cleaning and disinfection devices, drying cabinets, necessary accessories such as RFID scanners, and corresponding software licenses for uniform documentation in the inventory system. As part of the equipment exchange, the currently used space will be technically upgraded and adapted to current hygiene requirements. For this reason, pass-through machines should be offered which are clad from floor to ceiling with stainless steel and simultaneously serve as a spatial separation between the clean/unclean work areas. The new RDGEs must be able to hold at least 12 endoscopes. Peracetic acid will be used as process chemistry. For the safety of users and due to the lack of activated carbon filters in the room ventilation system, encapsulated canisters must be used to prevent inhalation contact with the chemistry. Due to space constraints and limited movement areas, the device doors should be designed as lift doors. The reprocessing of existing endoscopes must be approved and possible in the new devices; a list of devices is attached. This also applies to the reprocessing of balloon and Albarran channels. For hanging storage and drying of endoscopes, drying cabinets with at least 16 storage spaces should be provided, which should also be clad from floor to ceiling. Corresponding holders for the different types must be provided in sufficient quantities. The entire process from reprocessing and possible drying in the RDGE to drying in the drying cabinet must be validated. The documentation of the reprocessing must be fully digital. Currently, RFID transponders and the Hytrack software from Olympus are used for this purpose. Due to the planned spatial division, an additional standing workstation for documentation is provided. The license extension for this must be considered. The corresponding hardware (PC + holder) will be procured by the facility. Should the offered solutions not be compatible with the existing software or the existing RFID transponders, a concept paper (maximum 5 pages) must be submitted detailing how the connection will be realized, as well as pricing for the software solution including the required interface to Viewpoint and all hardware necessary for implementation. To ensure the renovation takes place during ongoing operations, the existing devices (3x ETD3 and 2xETD4) must first be gradually relocated to adjacent rooms and validated. A PMP-certified project manager must be provided for the entire project phase. Corresponding project management is expected from preparation and installation up to the actual acceptance. Due to structural requirements in the existing building, media connections must be made from the ceiling. The AEMP is located on the level below, so no penetrations through the floor are possible. Therefore, the devices must be installed in a floor tray. The drainage, depending on the manufacturer, may need to be realized via a drainage pump to the nearest shaft. This area has prestressed concrete ceilings, and the floor load is specified as a maximum of 5.0 kN/m2. Compliance with these limits while operating the RDGEs under full load is therefore mandatory. Depending on the installation variant and device footprint, a maximum weight per RDGE of approximately 580 kg can be achieved. Installation dimensions and maximum weight must be submitted for calculation. An existing system (ETD4) has not yet been fully depreciated and has a residual book value of EUR 21,914.22 as of April 1, 2026. This must be reimbursed accordingly within the scope of the renewal. The actual repurchase value will be calculated upon decommissioning at the start of construction. The relevant requirements of the Medical Device Implementation Act (MPDG), the Product Safety Act, and the Medical Device Regulation (MDR) must be met. The device must have CE certification...
Data provenance
This notice is sourced from TED - Tenders Electronic Daily (EU) and was originally published on April 23, 2026. Last refreshed 151 days ago. Original language: German. BidsFactory mirrors official procurement notices and links back to the source for full legal text.
About Medizinische Universität Lausitz - Carl Thiem KdöR
Medizinische Universität Lausitz - Carl Thiem KdöR has issued 153 procurement notices on BidsFactory, including 21 currently open and 21 awarded contracts. Activity concentrates in Education & Training, General Supplies & Services, and Information & Communication Technology. All notices are published for Germany. Notices are distributed via service.bund.de (Germany), Vergabe Brandenburg (Germany), and TED - Tenders Electronic Daily (EU). Most recent publication: November 16, 2026.
Frequently asked questions about this tender
Where will the contract be performed?
The contract is for delivery in Germany. Foreign bidders should review local registration, taxation, and any in-country presence requirements before submitting.
How can I submit a bid?
Visit TED - Tenders Electronic Daily (EU) to access the full notice, required documents, and submission instructions provided by the contracting authority.
Is this tender still open?
No — the contract has already been awarded to Olympus Deutschland GmbH. The award notice is archived on BidsFactory for transparency and market intelligence.
Who is the contracting authority?
This notice was issued by Medizinische Universität Lausitz - Carl Thiem KdöR in Germany. The authority is responsible for evaluating bids, awarding the contract, and managing performance.
What type of contract is this?
This is a Supplies contract in the Health & Medical sector. The classification helps bidders match the opportunity to their qualifications and registered scope of supply.
Find tenders like this automatically
Premium shows the full details of every tender like this one and alerts you instantly when a new one is published.
Sectors & Categories
Contracting Authority
Contact
Companies That Won Similar
Companies with awards in Health & Medical in Germany