Tenders/Qualification system for electric low-floor articulated buses
Open🇩🇪GermanySupplies

Qualification system for electric low-floor articulated buses

Auto-translated from German
Original title: Qualifizierungssystem Elektro-Niederflur-Gelenkbusse
Stadtwerke München GmbH
Published: Oct 30, 2026
Updated: Oct 31, 2026
Source: DÖE Bekanntmachungsservice (Germany)

About This Opportunity

This is a supplies contract in the information and communication technology sector, with a focus on Software and Hardware. Located in Germany, Europe, this opportunity is open to firms and consortiums.

Published through DÖE Bekanntmachungsservice (Germany), a national government procurement portal. Public procurement tenders follow the country's national bidding regulations and may have specific eligibility and documentation requirements for the supply of goods in the information and communication technology sector. Supply contracts typically require bidders to demonstrate product compliance with technical specifications, delivery capacity, and relevant certifications. Interested parties should review the full documentation on the original source before submitting their proposal.

Description

Auto-translated from German
Electric low-floor articulated bus with four doors (conductive charging via Combo 2/CCS and charging rails for top-down pantographs) with a minimum range of 300 km (BOL) (SORT II, Munich climatic conditions) Requirements for the vehicles: - Vehicle lifespan at least 12 years - Length 18 m – max. 18.25 m and height maximum 3.40 m (registration in vehicle registration document) with charging rails. - Passenger capacity of at least 100 people at 4 people / sqm on standing areas. - The battery life should be at least 6 years with daily use of 250 kilometers and meet the required range during this time (in winter with auxiliary heating). - If traction batteries are replaced after at least 6 years, it must be possible to replace the battery with the next generation (if available). - Charging power in the range of 100-150 kW at SOC 0 – 100%, average 100 kW at a charge level of 10-90%, charging curve with a maximum charging current of 200A from 0 -100% SoC must be attached. - Charging power via pantographs from 250 – 400 kW - Charging time must not exceed 5.5 hours (including preconditioning). - Diesel auxiliary heater suitable for GTL or optionally other biological liquid fuels. - Charging option via CCS Combo 2 plug via the wheel arches on the front axle left and right and via charging rails on the roof in the front section, VDV position. - DIN 15118 must be implemented in the communication between the charging station and the electric bus. The implementation of VDV guideline 261 for backend communication during the charging process must be implemented by the time of delivery. - Manufacturer must ensure that the current FMS standard is adhered to. - An air conditioning system as a heat pump must be provided with sufficient dimensions. Preferably, refrigerants with a lower GWP value than 5 should be used. - Barrier-free interior design according to UN/ECE Regulation 107 - The buses must comply with UN/ECE R 118 and the certificate must be submitted at the latest by the time of the offer. - 2 special use areas at door 2 for transporting mobility-impaired persons, clear lengths of 2m on the left vehicle side opposite door 2 and 1.30m on the right in front of door 2, as well as another special use area (stroller) at door 3 - Door 1 – Internal swing door (optional external swing sliding door) - Door 2 to 3/4 – External automatic swing sliding door - Folding ramp at door 2 - 2 x 29“ monitors in the passenger compartment and a 29“ monitor as a route display opposite door 2 - Video surveillance system - Passenger counting system Requirements for service and support (in case of order): In case of a tender, local support in the greater Munich area must be provided at least by a letter of intent. a) Branch office/contract workshop must be a commercial vehicle workshop competent in buses. b) A standby service must ensure that service staff can be on-site at the Stadtwerke München depot within two hours on weekdays. c) After delivery of the second vehicle per delivery lot, a permanent presence of a service technician for 6 weeks must be guaranteed. If the delivery of the entire lot is not possible within this 6-week period, the permanent presence of the service technician will be extended until 6 weeks after the delivery of the last vehicle per delivery lot. d) Spare parts supply must be guaranteed for the entire lifespan. e) A branch office or representative within a 1-hour bus travel time from the starting point Georg-Brauchle-Ring 55 80992 Munich must be designated as the main support contact point, and at least one further service base must be located in the Munich metropolitan region. f) Proof of short-term delivery capability of common spare parts when ordered by 3:00 PM with delivery by 10:00 AM the next working day. g) If the requirements (a-f) are not currently met, a concept for fulfilling them in case of an order must be attached to the application.

Data provenance

This notice is sourced from DÖE Bekanntmachungsservice (Germany) and was originally published on October 30, 2026. Last refreshed 17 days ago. Original language: German. BidsFactory mirrors official procurement notices and links back to the source for full legal text.

About Stadtwerke München GmbH

Stadtwerke München GmbH has issued 302 procurement notices on BidsFactory, including 21 currently open and 110 awarded contracts. Activity concentrates in Architecture & Engineering Services, Construction & Civil Works, and Information & Communication Technology. All notices are published for Germany. Notices are distributed via TED - Tenders Electronic Daily (EU), DÖE Bekanntmachungsservice (Germany), and BayVeBe Bayern (Germany). Most recent publication: November 18, 2026.

Stadtwerke München GmbH: buyer profile, tenders and awards

Frequently asked questions about this tender

What type of contract is this?

This is a Supplies contract in the Information & Communication Technology sector. The classification helps bidders match the opportunity to their qualifications and registered scope of supply.

Where will the contract be performed?

The contract is for delivery in Germany. Foreign bidders should review local registration, taxation, and any in-country presence requirements before submitting.

How can I submit a bid?

Visit DÖE Bekanntmachungsservice (Germany) to access the full notice, required documents, and submission instructions provided by the contracting authority.

Who is the contracting authority?

This notice was issued by Stadtwerke München GmbH in Germany. The authority is responsible for evaluating bids, awarding the contract, and managing performance.

Find tenders like this automatically

Premium shows the full details of every tender like this one and alerts you instantly when a new one is published.

See plans

Key Details

Contract Type
Supplies
Eligibility
Firms / Consortiums
Language
German

Source

oeffentlichevergabe_de
DÖE Bekanntmachungsservice (Germany)
Public Procurement

Contracting Authority

Stadtwerke München GmbH
🇩🇪Germany